Finishing Up - TYAN S5221 User Manual

J16: 24-Pin EPS 12V PWR main Connector
Note:
YOU MUST unplug the power supply before plugging the
power cables to motherboard connectors.

2.14 - Finishing Up

Congratulations on making it this far! You have finished setting up the
hardware aspect of your computer. Before closing up your chassis, make
sure that all cables and wires are connected properly, especially IDE cables
and most importantly, jumpers. You may have difficulty powering on your
system if the motherboard jumpers are not set correctly. In the rare
circumstance that you have experienced difficulty, you can find help by
asking your vendor for assistance. If they are not available for assistance,
please find setup information and documentation online at our website or by
calling your vendor's support line.
Signal
+3.3V
+3.3V
GND
+5V
GND
+5V
GND
PS_GD
5VSB
+12V
+12V
+3.3V
28
http://www.TYAN®.com
Pin Pin Signal
1 13 +3.3V
2 14 -12V
3 15 GND
4 16 PS_ON
5 17 GND
6 18 GND
7 19
GND
8 20 Reset
9 21 +5V
10 22 +5V
11 23 +5V
12 24 GND