Table of Contents
Advertisement
Article VI. Create a WDS Bridge
between two APs
WDS link creation will assist to extend network coverage where running wires is not an option, effectively
transferring the traffics to the other end of WLAN/LAN through the EAP-300. Since this is a peer to peer
connection, both EAP-300s will be configured by the same way.
Step 1: Make sure the Band and Channel Match between the WDS peers
In order to successfully communicate, the two EAP-300s must be configured to use the same channel
and band for its wireless settings. Click the Wireless icon followed by the General tab to reach the
following page.
Here, simply make sure that both APs are using the same Band and Channel in order to establish a
successful WDS link. Click SAVE if any changes have been made.
Wireless General Settings Page
32
Advertisement
Table of Contents
