Connecting To Power; Connecting To Your Network - Planet NOVASwitch FNSW-8086F User Manual

Connecting to Power

Connect the supplied AC power cord to the receptacle on the
back of the switch, and then plug the cord into a standard AC
outlet with a voltage range from 100 to 240 VAC.
Turn the Ethernet switch on by flipping the ON/OFF switch on
the rear of the unit to the I (ON) position. The O position is OFF.

Connecting to Your Network

10/100BASE-TX TP Ports
Connect cables to computers or network segments into the RJ-
45 ports on the front of this switch. It does not matter which port
you select. All the non-fiber ports support 10BASE-T or
100BASE-TX with full or half duplex.
Use the uplink port with the uplink button pressed down for
connecting to a regular (i.e. non-uplink) port of a hub or another
switch. If connecting to an uplink port of a hub or another switch,
any of the eight ports can be used. To connect two regular RJ-
45 ports between any two switches or hubs, you need a cross-
wire cable.
The cable must be a Category 5 shielded twisted-pair or
unshielded twisted-pair (STP/UTP) cable for 100BASE-TX, or
Category 3, 4, or 5 STP/UTP cable for 10BASE-T.
100BASE-FX Fiber-optic ports
14 NOVASwitch Series