General Information
"
"
Resetting
In the rare event that your Industrial Mobile Computer
fails to respond to your input, it may be necessary to
"reset." To reset press the [Gold], [Esc], and [0] keys at the
same time, hold the keys down for three seconds, and your
computer will reboot. Resetting takes you to the start up
screen.
Reset keys
Customer Response Center and Product
Service
Factory Service
If your unit is faulty, you can ship it to your nearest
authorized Service Center for factory-quality service. The
address and telephone number are included on the Product
Service Information Card shipped with your product.
1-10
NORAND
R
600 Series Industrial Mobile Computer User's Guide
The 600 Series Single/Vehicle Dock provides a stan-
dard PC compatible DB-9 (male) serial port.
The 600 Series Multidock converts the signals from
the computer's RS-232 serial port to RS-485 and
brings out an RS-485 bus to two DB-9 female connec-
tors compatible with Norand RS-485 networking.
Figure 1-5
Resetting your Computer
SECTION 1