Fitting The Canopy Hood - Zanussi ZHC 925 Instruction Booklet

Fitting the Canopy Hood

Before starting to fix the canopy it will be
necessary to adjust the support brackets
S1 by turning the screws clockwise until
the limit of the thread is reached as
illustrated in Fig. 8.
a- Hook the canopy onto the two
4.2x44.4mm screws1 fitted as described
above and illustraed in Fig. 9.
b- Using a screw driver and spirit level,
adjust the screws S1 until the canopy is
level. Once the canopy is level, tighten
up the wall fixing screws to secure the
canopy.
Electrical connection and working
test
Before fitting the chimney to the canopy make
the electrical connection as described in the
section titled "ELECTRICAL CONNECTION".
When the electrical connection has been made,
test the three speed fan and worktop
illumination.
Venting
The hood is more effective when used in the
extraction mode (ducted to the outside).
Venting kits may be purchased through your
retailer or DIY store, and must be ducted to
an outside vent of 125mm (5").
The ducting used must be manufactured
from fire retardent material conforming
to the relevant British Standard or DIN
4102-B1.
When the cooker hood is ducted to the
outside the charcoal filter must be removed.
Recirculation
The cooker hood is supplied specified for use
in the recirculation mode, with the charcoal
filters fitted.
In the recirculation mode contaminated air is
passed through the charcoal filters to be
purified and recirculated into the kitchen
through the grille outlets on either side of the
chimney (G).
To assemble the recirculation duct, place the
'push-fit'recirculation extension pipe P over
the spigot on the top of the canopy; place the
'push-fit' spigot R on to the pipe P and insert
the extension pieces P1 into either side of the
spigot as illustrated in Fig. 10.
P1 P1
R
P
14
S1
Fig. 8
1
1
Fig. 9
I
Fig. 10
S1
1
G