Fitting The Chimney Stack - Zanussi ZHC 925 Instruction Booklet

Fitting the Chimney Stack

The chimney consists of two sections. The upper
chimney measures 215mm and the lower chimney
(with the holes for recirculation on either side)
measures 728.5mm.
To fit the upper section (S) first expand
the chimney slightly to allow it to be fitted
over the brackets 2, and then secure the
chimney stack to brackets using the four
self tapping screws provided as illustrated
in Fig. 12.
To fit the lower chimney section (I) expand
the chimney slightly to allow it to be fitted
over the upper chimney (S) and the
canopy (C) as illustrated in Fig. 8.
Secure the bottom of the chimney to the
canopy using the self tapping screws
provided as illustrated in Fig. 12.
After the chimney has been secured into
position, insert the two plastic
recirculation grilles in to the apertures on
each side of the chimney. The grilles are
marked with two arrows and should be
fitted with one arrow pointing upwards and
the other toward the front.
When the hood is used in the recirculation
mode ensure that the grilles are properly
secured to the recirculation spigot R as
illustrated in Fig. 13.
S
I
C
16
2
2
G
Fig. 12
Fig. 13