Pride Mobility Jazzy 1103 Owner's Manual page 23

V I . C O M F O R T
ANTI-TIP WHEEL ADJUSTMENT
The Jazzy 1103 mid-wheel drive design provides superior performance and safety. The anti-tip wheels are an
integral part of this design because they provide you with stability during deceleration. The anti-tip wheels are
preset at the factory to a height of 1,25 cm off the ground. This is the ideal setting for most Jazzy 1103 users.
However, you may encounter situations where you may need to adjust the anti-tip wheels. For instance, if you
drive your Jazzy on surfaces, such as deep pile carpeting, you may notice that the anti-tip wheels have a tendency
to drag on the carpet. In this case, you may need to raise the anti-tip wheels. If you drive your Jazzy primarily on
smooth surfaces, such as linoleum or tile, you may find that you are tipping forward more than is comfortable for
you. (This may be more apparent for lighter users.) In this case, you may need to lower the anti-tip wheels.
WARNING! Consult your Pride provider before attempting to change the anti-tip wheel height.
Changing the height affects handling under deceleration.
Required Tools: 1/2-in. wrench, 5/32-in. hex key, 3/4-in. wrench
To adjust the anti-tip wheel height:
1. Remove the seat, body shroud, and the
batteries. See III. "The Jazzy 1103" and V.
"Operation."
2. Locate the jam nut and setscrew on the anti-
tip assembly. See figure 13.
3. Use a 1/2-in. wrench to loosen the jam nut.
4. Use a 5/32-in. hex key to turn the setscrew.
Turn the setscrew clockwise to raise the anti-
tip wheel. Turn the setscrew counterclockwise
to lower the anti-tip wheel.
5. Tighten the jam nut.
AUS Jazzy 1103 Rev E/Sep02
A D J U S T M E N T S
Figure 13. Anti-tip Height Adjustment
www.pridemobility.com
SETSCREW
JAM
NUT
23