Preparing Your Projector - Mitsubishi Electric XD8500U User Manual

Preparing your projector

Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in
the package.
Cable
Mini D-SUB
15-pin
Computer cable
(246C597-20)
Remote control parts
Remote control
(290P188-30)
Important:
1
2
Caution:
terminals. If you dispose of the batteries together with other conductive objects such as a metal piece, they may short
out, resulting in fire or explosion.
Batteries may explode if misused. Do not recharge, disassemble, or heat the batteries, or put them into fire or water.
with your eyes, rinse them with water and then consult your doctor.
may short out, causing explosion or liquid leakage and resulting in fire or injury.
High temperature and high humidity may cause corrosion or liquid leakage.
Mini D-SUB
15-pin
R6 (size-AA)
battery (two)
3
Power supply parts
Power cord (two)
(246C684-10, 246C383-20)
Others
Lens cap (attached to the projector)
Lamp replacement tray
Power cord holder
CD-ROM
Safety Manual/Quick Start up
Mitsubishi logo plate
Inserting the batteries into the remote control
1. Remove the rear lid of the remote control.
2. Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
the (-) side is difficult because the coil spring end hits
on the battery side. If the battery is forced to insert in
this way, the outer label of the battery may get ripped
and it may cause a short-circuit and heating.
3. Attach the rear lid.
Important:
control is slow to operate.
Removing the batteries from the remote control
Remove the back lid of the remote control and take out the
batteries.
EN-6