Preparing Your Projector - Mitsubishi Electric HC8000D User Manual

Preparing your projector

What's included in the box
AC power cord* for the U.S.
for Europe
for the U.K.
for Australia
for South Korea
Computer cable
Mini DIN 5-pin cable
* One of power cords for the U.S., Europe, U.K., Australia, and South Korea is provided appropriately.
Important:
• The attached power cord is to be used exclusively for this product. Never use it for other products.
Inserting the batteries into the remote control
1
2
Removing the batteries from the remote control
Remove the back lid of the remote control and take out the batteries.
Caution:
• Use of a battery of wrong type may cause explosion.
• Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
• Dispose of used batteries according to your local regulations.
• Before you dispose of the batteries, insulate them by placing insulation tape on the positive (+) and negative (-)
terminals. If you dispose of the batteries together with other conductive objects such as a metal piece, they may
short out, resulting in fire or explosion.
• Batteries may explode if misused. Do not recharge, disassemble, or heat the batteries, or put them into fire or
water.
• Be sure to handle the batteries according to the instructions.
• Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.
• Keep batteries out of reach of children and pets. If children swallow the battery, see a doctor immediately.
• Remove the batteries, if the remote control is not used for a long time.
• Do not combine a new battery with an old one.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in
contact with your eyes, rinse them with water and then consult your doctor.
• Do not carry or store the batteries together with metallic ballpoint pens, necklaces, coins, or hairpins. Otherwise,
they may short out, causing explosion or liquid leakage and resulting in fire or injury.
• Do not store the batteries where they are exposed to direct sunlight or subjected to high temperature and high
humidity. High temperature and high humidity may cause corrosion or liquid leakage.
J2552-0063-03
J2552-0247-01
J2552-0065-02
J2552-0053-00
J2552-0247-01
J2552-0072-07
02552-0388-00
3
EN-6
Remote control
User Manual/Quick Start up (English only)
Safety Manual/Quick Start up
CD-ROM (with User Manual)
Battery (2)
Lens cap
Lamp replacement attachment
1. Remove the back lid of the remote control.
2. Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
• If the battery is inserted from the (+) side first,
inserting the (-) side is difficult because the coil spring
end hits on the battery side. If the battery is forced in
this way, the outer label of the battery may get ripped
and it may cause a short-circuit and heating.
3. Attach the back lid.
Important:
• Use two size-AA batteries (R6).
• Replace the two batteries with new ones when the
remote control is slow to respond.