Troubleshooting (continued)
Others (continued)
Problem
"TEMPERATURE!!" is
displayed.
The
mark appears.
The remote control
doesn't function easily
or at all.
The buttons on the
projector (except for
the POWER button)
don't function.
Abnormal sound is
heard.
FOCUS/ZOOM
doesn't work.
Lens shift doesn't
work.
If the following problem occurs after the lamp is replaced, check the following first.
Problem
The projector does not
turn on.
The LAMP indicator
illuminates red.
Kensington Lock
This projector has a Kensington Security Standard connector for use with Kensington MicroSaver Security System.
Refer to the information that came with the Kensington System for instructions on how to use it to secure the
projector. Please contact Kensington Technology Group below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone: +1- (650)572-2700
Solution
temperature stays high, the lamp goes out.
Eliminate any causes of the rise in the ambient temperature.
kept blocked, the lamp goes out.
Remove the objects blocking the intake or exhaust vents.
This mark appears when ineffective operation is carried out. This isn't a product malfunction.
weak. (See page 6.)
light. (See page 9.)
and 62.)
connected to the REMOTE 1 IN terminal. (See page 63.)
enable the password lock.
Cancel the password lock or contact the person in charge of management of the
projector. (See page 58.)
connected to the REMOTE 1 IN terminal. (See page 63.)
occasions. Such symptom is not a malfunction.
Solution
Fax: +1- (650)572-9675
EN-72
to
(See page 34.)