Napoleon GSS48 Manual page 25

Once the glass tray is removed from the fireplace flip the glass tray upside down and remove the nuts
from the bottom of the burner.
Reinstallation: Reverse the procedure to reinstall the burner ensuring that the holes on the gasket
between the burner bracket and glass tray are lined up during re-assembly. Check that the orifice enters
the burner when installing. Replace the glass embers and the front glass shield. When the appliance is put
back in service, check the burner flame pattern with the image below.
NORMAL
ABNORMAL
Cleaning The Outer Appliance Surface: Do not use abrasive cleaners or steel wool on any painted, or
stainless steel parts of your Napoleon Appliance. Doing so will scratch the finish. Exterior surfaces should
be cleaned with warm soapy water. To clean stainless surfaces, use a stainless steel or a non-abrasive
cleaner. Always wipe in the direction of the grain. Over time, stainless steel parts discolor when heated,
usually to a golden or brown hue. This discoloration is normal and does not affect the performance of the
appliance
WARNING!
The appliance area must be clear and free from combustible materials, gasoline and
other flammable vapors and liquids. Do not obstruct the flow of combustion and ventilation air. Keep
the ventilation opening of the cylinder enclosure free and clear of debris.
25
EN
www.napoleongrills.com