Troubleshooting - Gio Electric Italia 500W Manual

Operator, Safety, And General Maintenance Manual

11 Troubleshooting:

Issue
No power / no lights
Power ON but scooter doesn't run
Charger not working
Battery not charging
Short running distance
Scooter doesn't stop when applying
brakes
Page | 17
Italia 500w Electric Scooter Owner Manual.indd 17
Possible cause
Key switch off
Kill switch
Circuit breaker / fuse
Battery not connected
Battery not charged
Ignition switch wires disconnected
Wires to circuit breaker
disconnected
Brakes safety switch is engaged
Throttle connection
SLA battery not connected
Battery discharged
Wires to brain module loosen
Motor wires disconnected
Brain module defective
Motor defective
No voltage in power outlet
Charger defective
Charger not working
SLA battery not connected
Battery not fully charged
Brakes not adjusted
Battery is old and not holding a
charge
Brakes not adjusted
Brake cable loosen
MANUAL
Solution
Turn ignition switch ON
Turn kill switch ON
Turn circuit breaker ON / check fuse
inside the battery
Connect the batteries
Charge the battery
Check wires connection to ignition set
Reconnect wires to ignition switch
Check that brake levers are released –
not applied.
Check throttle wires for proper
connection
Check and connect both packs. In some
cases the wire that connects both packs
might be defective.
Charge battery
Check and reconnect wires to brain
module
Check and reconnect wires to the motor
Replace brain module
Replace motor
Connect other device in the same outlet
and check for operation
Replace charger
Check charger
Check and connect both packs. In some
cases the wire that connects both packs
might be defective.
Charge the battery
Adjust brakes
Replace battery
Adjust brakes
Place brake cable in proper position
17
2/5/2014 10:36:14 PM