Connections On The Rear Panel - Bosch PLN-24CH12 Installation And Operation Manual

10 en | System Overview
3.4.2

Connections on the rear panel

Figure 3.2 Rear view of battery charger
A
B
C
D
E
F
180110011Aa | V1.1 | 2011.05
A B
7 8
1
E
Mains power socket
Auxiliary output terminals
Temperature sensor socket
Main output terminals
Output contacts
Battery terminal
Installation and Operation manual
9
2 3 4
D
Socket for connecting the battery charger to the
mains power. The socket has a built-in strain relief.
Three terminals for connecting auxiliary outputs (5
A max.) to power modules of the Voice Alarm
System that do not have mains power inputs. The
outputs are protected by a fuse (Faux1 to Faux3).
Socket to connect the temperature sensor (see
section 6.6 ).
Six output terminals to connect to the back-up
power terminals of VAS equipment (40 A max.).
The outputs are protected by a fuse (F1 to F6).
Fail-safe, dry contact, three-pole SPDT switch (C-
NC-NO), allowing 1A at 24 Vdc or 0,5 A at 120 Vac:
- Mains status (5 sec. of delay after mains fault)
- Battery status
- Output voltage status
Terminal for connecting the battery leads (150 A
max.).
Battery Charger
5 6
C F
Bosch Security Systems B.V.