Connecting With An S-Video(Y/C)Cable - Philips DVD Recorder Manual

Menu Language
English
Español
Français
Italiano
Deutsch
Press OK to continue
Connecting the DVD recorder
Virgin mode
a My screen is empty.
b Many TV sets are switched by the DVD recorder to the programme
b If the TV set does not automatically switch to the scart socket programme
b Check that the scart cable is connected from the TV set to the EXT 1
Then, read the paragraph on 'Initial installation' in 'Installing your DVD recorder'.
Connecting with an S Video(Y/C)cable
This connecting cable, also known as the SVHS cable, is used to transmit the brightness signal (Y
signal) and colour signal (C signal) separately. This mini DIN socket/plug is also called a Hosiden
socket/plug.
Have the following cables ready:
an aerial cable (1, supplied), a mains cable (2, supplied), an S-Video(SVHS) cable (3), an audio
cable (4, red/white plug).
1
Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN socket at the back of the DVD recorder.
2
Insert one end of the supplied aerial cable into the TV OUT socket at
the back of the DVD recorder and the other end into the aerial input
socket at the back of the TV set.
3
Insert one end of an S-Video(SVHS) cable into the OUT S-VIDEO
(Y/C) socket at the back of the DVD recorder and the other end into
the S-Video (SVHS) input socket on the TV set (usually labelled
'S-Video in' or 'SVHS in'. See TV operating instructions).
number for the scart socket by way of a control signal sent through the
scart cable.
number, manually change to the corresponding programme number on your
TV set (see your TV's operating instructions).
TO TV-I/O socket on the DVD recorder. The EXT 2 AUX-I/O socket is
intended only for additional devices.
Problem
15