Hardware Installation; Driver Installation - StarTech.com SATDOCK22R Instruction Manual

Hardware Installation

JBOD Mode
1. Connect the external power adapter to the Hard Drive Dock.
2. Install 1 or 2 hard drives into the dock in either drive bay.
3. The Mode button LED should be blue to indicate JBOD mode. Press
and hold the Mode button for 3 seconds to switch modes.
4. Connect the USB cable from the hard drive dock to the computer
system.
5. The operating system should now detect the hard drive(s) and
make them available. The hard drives may need to be partitioned/
formatted using a disk management utility before you can access
them.
Duplicator Mode
1. Connect the external power adapter to the Hard Drive Dock.
2. Install 2 hard drives into the dock. Make sure to place the drive
with the data you want copied (Source) into the "Source" bay. The
destination disk (Destination) should be equal or larger in capacity
than the source disk.
3. The Mode button LED should be red to indicate Duplicator Mode.
Press and hold the Mode button for 3 seconds to switch modes.
4. Once both drives are installed, press the Start button to begin
duplication.

Driver Installation

Windows 2000/XP/Vista, Mac OS X, Linux kernel
No driver installation is required for these operating systems, as
this hard drive dock is natively supported, so the drivers are already
installed.
3