Headphones Level Setup Sub-Menu; Osd Setup Sub-Menu; Osd Position Sub-Menu - Integra DTR-7.2 Instruction Manual

Preference

4-2. Headphones Level Setup sub-menu

You can use this sub-menu to adjust the volume output from the
headphones so that it matches the level output from the speakers.
The headphone volume can be adjusted between –12 and +12
decibels.
Advanced Menu
4.Preference
4-2.HeadphoneLevel Setup
a.Headphones Level

4-3. OSD Setup sub-menu

This sub-menu allows you to customize the OSD Setup menu to
display in the manner you desire.
Advanced Menu
4.Preference
4-3.OSD Setup
a.Background Color
b.Superimpose Mode
c.Immediate Display
d.Display Position
a. Background Color
Select either Blue1, Blue2, Green1, Green2, Magenta, Red1, or
Red2 as the background color while the OSD Setup menu is
displayed.
b. Superimpose
Off: Select to have the OSD Setup menu displayed on the
selected background color.
Normal: Select to have the OSD Setup menu superimposed over
the current video if one is displayed or on the selected
background color if there is no video signal.
Black: Select to have the OSD Setup menu displayed on a black
background at all times.
c. Immediate Display
On: Select this to have the screen immediately display certain
operations as you perform them. The display will remain for a
few seconds after the operation is completed.
Off: Select this to turn off the immediate display of operations.
: 0dB
Quit:|SETUP|
:Blue1
:Normal
:On
:Bottom
Quit:|SETUP|
VIDEO 1
Hint:
If this is set to "Off," the background color will not be displayed
even when there is no video signal input.
d. Display Position
Use this setting to select the position of the immediate display that
appears when certain operations are performed. You can position the
immediate display at any of ten different levels ranging from the top
all the way to the bottom.

4-4. OSD Position sub-menu

This sub-menu allows you to adjust the position of the OSD Setup
menu as it is displayed on your screen. Depending on the monitor
used, there may be cases where the OSD Setup menu is not displayed
in the center and parts of the menus are cut off. To adjust the position
of the OSD Setup menu, simply press the cursor buttons to inch the
menu to position you desire.
Advanced Menu
4.Preference
123456789012345678901234
4-4.OSD Position
1
2
3
4
5
6
7
8
9
0
1 Exit:|RETURN|
2
47