Integra DTA-70.1 Instruction Manual page 12

DTA-70.1_En_100108.book Page 12 Friday, January 8, 2010 2:04 PM
Connecting the Amplifier—Continued
Connecting the Speaker Cables
1
Strip about 1/2" to 5/8"
(12 to 15 mm) of insu-
lation from the ends of
the speaker cables,
and twist the bare
wires tightly, as
shown.
2
Unscrew the terminal.
The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one
surround back speaker, connect it to the SURR BACK L terminal.
Note:
If you use front high or front wide speakers, you must turn on the AV controller and select the speakers to be used.
For more details, see the instruction manual of the connected component.
Surround
right
speaker
Front high/wide Surround
right speaker back right
speaker
12
3
1/2" to 5/8"
(12 to 15 mm)
4
Select 4Ω or 6Ω.
Front right Center
speaker speaker
Fully insert the bare wires.
Screw the terminal tight.
Front left Surround
speaker left
speaker
Surround Front high/wide
back left left speaker
speaker