Connecting Your Vcr To The Tv Using The Coaxial Cable; Connecting Your Vcr To The Tv Using The Scart Cable; Connecting A Decoder For Scrambled Pay Tv Broadcasts - Samsung SV-635X Instruction Manual

Connecting Your VCR to the TV using the Coaxial Cable

To receive television programmes a signal must be received from
one of the following sources:
ORTIE
D
AUDIO
G
TV
2
1 Remove the aerial or network input cable from the television.
2
Connect this cable to the 75Ω coaxial socket marked
rear of your VCR.
TV
3 Plug the coaxial cable supplied into the
SORTIE
D 4
Plug the other end of the coaxial cable into the connector
AUDIO
G
TV
previously used for the aerial on the television.
5
To obtain better quality pictures and sound on your television, you
3
can also connect your VCR to the television via the SCART cable
4
(see section below) if your television is equipped with this type of
connection.

Connecting Your VCR to the TV using the SCART Cable

Aerial
OUT
R
AV2(DECODER/EXT.) AUDIO
4
L
TV
AV1(EURO AV)
2
You can connect your VCR to the television using the SCART cable if the appropriate input is available on
the television. You thus:
Obtain better quality sound and pictures
Simplify the setting up procedure of your VCR
Regardless of the type of connection chosen, you must always connect the coaxial cable
supplied. Otherwise, no picture will be visible on the screen when the VCR is switched off.
Make sure that both the television and the VCR are switched off before connecting the cables.
You can connect your VCR to a Hi-Fi system.
Example: You wish to take advantage of the quality of your Hi-Fi stereo system when watching a
programme or recording via your VCR.
1
Connect the coaxial cable as indicated in the above section.
2
Connect one end of the SCART cable to the AV1(EURO AV) socket on the rear of the VCR.
3
Plug the other end into the appropriate connector on the television.
4
Plug the RCA Audio cable with stereo system into the Audio out socket on the rear of the VCR.
(SV-635X/SV-631X/SV-6315X/SV-6313X/SV-530X only)
10
An outdoor aerial
An indoor aerial
A cable television network
A satellite receiver
Make sure that both the television and the VCR are
switched off before connecting the cables.
on the
TV socket on your VCR.
TV
RF coaxial cable
3
SCART Cable
(SV-635X/SV-631X/SV-6315X/SV-6313X/SV-530X only)

Connecting a Decoder for scrambled PAY TV broadcasts

DECODER
AV1(EURO AV)
SCART Cable
3
OUT
AV2(DECODER/EXT.)
2
AV1(EURO AV)
SCART Cable
This VCR is fully equipped to receive scrambled Pay TV broadcasts.
Example: CANAL+ or Premiere broadcasts.
You can:
Record a scrambled programme while watching another channel
Record another channel while watching a scrambled programme
When the DECODER is connected to the AV2 socket, AV2 SET must be set to DEC (see page 22)
1 Connect the VCR to the television as indicated on page 10.
2 Plug the SCART cable with the decoder into the AV2(DECODER/EXT.) socket on the rear of the VCR.
3 Plug the other end into the decoder.
Aerial
TV
Aerial Connector
R
AUDIO
L
TV
11
GB