Configuring Wan - Huawei ICE D-20 EC506 User Manual

User Guide
ICE D-20 Wireless Broadband Gateway
Bridges: The physical address of the remote peer bridge. D-20 supports P-to-P
bridge mode. One D-20 can connect with four remote peer bridges.
Peer MAC Address: The physical address list of the remote peer bridges. Up to
four physical addresses can be filled in.
Link Status: Two statuses are available, up and down. up means bridging is
successful and down means bridging is unsuccessful.
MAC Restrict Mode: Three options are listed in Table 3-3. By default, it is
Disabled.
Table 3-3 MAC restrict mode parameter description
Parameter
Disabled
Allow
Deny
MAC Addresses: MAC addresses list. D-20 controls the access to the clients
whose addresses are listed in the MAC address list. Up to 16 MAC addresses can
be saved in the list.
Authenticated Stations: The information of wireless terminals that logs in to D-20
through authentication.

3.3.5 Configuring WAN

I. Configuring the parameters of WAN connection
The steps of entering WAN configuration page are shown as follows.
1) Click Advanced in the operation navigation area.
2) Click WAN in the unfolded navigation tree to display the parameter configuration
page of WAN. In this page, you can set the PPP parameters and parameters for
connecting the CDMA network. Click Apply to save your settings. Figure 3-10
shows the configuration page.
MAC address filter function is disabled.
The wireless terminals corresponding to the MAC addresses
in the MAC addresses list are allowed to access D-20
through WLAN.
The wireless terminals corresponding to the MAC addresses
in the MAC addresses list are forbidden to access D-20
through WLAN.
Huawei Technologies Proprietary
3-10
Description
Table of Contents