Unpacking And Installation - Sharp AR-5316 Service Manual

[5]UNPACKING AND INSTALLATION

5. Changing a tray's paper size setting
Follow these steps to change a tray's paper size setting.
Note:
•The paper size setting cannot be changed when the machine has
stopped temporarily due to running out of paper or a misfeed, or during
interrupt copying.
•During printing (even in copy mode), the paper size setting cannot be
changed.
•Do not load paper that is a different size than the paper size setting.
Copying will not be possible.
1) Hold down the [PAPER SIZE ENTER] key for more than 5 seconds to
set the selected paper size.
The currently selected paper feed location indicator will blink and the
corresponding paper size (which is currently set) indicator will light
steadily.
All other indicators will go out.
GINAL
11
X
8½
X
8½
X
8½
X
8½
X
EXTRA
2) Use the [ORIGINAL SIZE ENTER] key to select the paper size.
The indicator of the selected paper size lights up.
GINAL
11
X
ORIGINAL SIZE
8½
X
ENTER
8½
X
8½
X
8½
X
EXTRA
PAPER
SIZE
17
14
11
5½
11
PAPER
SIZE
17
14
11
5½
11
AR-5316 UNPACKING AND INSTALLATION 5-1
3) Squeeze the lock lever of the front guide and slide the front guide to
match the width of the paper, and move the left guide to the
appropriate slot as marked on the tray.
Left guide
•The front guide is a slide-type guide. Grasp the locking knob on the
guide and slide the guide to the indicator line of the paper to be loaded.
•The left guide is an insert-type guide. Remove it and then insert it at the
indicator line of the paper to be loaded.
•When using 11" x 17" sized paper store the left guide in the slot at the
left front of the paper tray.
4) Press the [START] key and then the [PAPER SIZE ENTER] key.
To change the paper size setting of another tray, repeat steps 2) to 4)
after pressing the [START] key.
START
Note: Affix the paper size label for the paper size selected in step 2) to
the label position on the right end of the tray.
Important points when using the printer mode
•Make sure that the tray's paper size setting is the same as the tray's
paper size setting in the printer driver. For example, if the tray's paper
size setting is 8-1/2"x11R, set "Setting Paper Size" to "Letter R". For
more information, see "CONFIGURING THE PRINTER DRIVER" in the
"Software Setup Guide".
Front guide