Sharp AR-5316 Service Manual page 21

Main Sub
Contents
code code
46 19 Exposure mode setting
(Gamma table setting / AE
operation mode setting / PHOTO
image process setting)
49 01 Flash ROM program writing mode (Operating procedure)
Used set for the following three exposure mode. Enter a code number and press the [START] key,
and the entered number is written into the EEPROM and the machine goes into the sub code entry
standby mode. (When the [Copy mode select] key is pressed, the number is written into the
EEPROM and the set item is changed.)
<<Gamma table setting>>
When this simulation is executed, the current set code number of gamma table is displayed.
(Default: Japan -1. EX Japan -2)
* When setting the gamma table, no "Mode lamps" are lighted.
Code number
1 Image quality priority mode
2 Toner consumption priority mode
* If this setting is changed, the set content of SIM46-30 is reset to the default.
<<AE mode>>
When the [Copy mode select] key is pressed in gamma table setting, the mode is changed to the AE
operation mode setting and the current set code number of the AE operation mode is displayed.
(Default: 0)
* When setting the AE operation mode, the "AE mode lamp" is lighted.
Code number
0 Lead edge stop
1 Rear time process
<Photo image process setting>
When the [Copy mode select] key is pressed during the AE operation mode setting, the setting mode
is changed to the photo image process setting and the currently set code number of the photo image
process setting is displayed.
* When in the photo image process setting, the [Photo mode lamp] is lighted.
Code number
1
2
* When this setting is changed, SIM 46-1/2/18/29 and SIM 46-31 Photo items are reset to the
default. (SIM 46-11 is also linked.)
When this simulation is executed, "d" is displayed on the copy quantity display and the machine
enters the Flash ROM program writing mode. Use the writing tool on the PC to write the program.
During writing, the display is made as follows. After completion of downloading, turn OFF/ON the
power to reset.
Status
Download data reception
Data delete start
Data writing (Boot section)
Data writing (Program section)
Sum check
Completion of downloading
Error status
* "*" in the error display indicates the error position.
00 Data receive error
02 FLASH ROM delete error
03 FLASH ROM write error (Boot section)
04 FLASH ROM write error (Program section)
05 Sum check error (Loader section)
06 Sum check error (Boot section)
AR-5316 SIMULATIONS 7-5
Details of operation
Setting (Gamma table)
Setting (AE operation mode)
Setting (Photo image process setting)
Error diffusion process
Dither process
Copy quantity display Pre-heat lamp
"d"
"d"
"d"
"d"
"d"
"OFF"
"*E"
07 Sum check error (Program section)
08 Sum check error (EEPROM section)
09 E2PROM verify error
0b E2PROM verify error
0F Download data length error
* Default for Japan models
* Default for EX Japan models
* Default
* Default
Ready lamp
ON OFF
ON ON
Flash OFF
Flash Flash
ON ON
OFF OFF
OFF OFF