Electrolux Diva Service Manual page 26

No. flashes
Displayed
Type of of end-of-
to the
alarm cycle LED
user
and "beeps"
i60 6 NO
i70 7 NO
i80 8 NO
i90 9 NO
ib0 11 NO
id0 13 NO
iF0 15 NO
(*) If it is not possible to access diagnostics mode, switch the appliance off and then on again to check that this is not caused by a temporary fault. Before replacing the
circuit board, check that it is correctly powered by controlling the following
Continuity of the power cable
Correct operation of the suppressor
Closure of the door switch contacts
Continuity of the wiring between connectors A2/B1 on the circuit board and the suppressor.
SOI/TD PR
Description of the alarm condition
Heating Time-out
(the check takes place every 3 minutes:
the temperature must increase by a
certain amount at each step)
NTC sensor short-circuited or open
Communication error between the
microprocessor and the EEPROM
Problems with software configuration
Problems with the turbidity meter
[if featured] (Calibration Time-out)
Problems with the washing motor: no
signal from the tachymetric generator
(washing pump powered, but no signal
from the generator)
Water replenishment Time-out
(3 times during the T.S. Time-out)
Machine status
The programme continues to the
end without heating (the washing
result will probably be
unsatisfactory)
The programme continues to the
end without heating (the washing
result will probably be
unsatisfactory)
Machine inoperative: no selection
possible (*)
The fault occurs when switching
on: no selection possible (*)
The programme continues as if a
"heavy soiling" condition had been
detected.
The heating element is switched
off. If the fault persists after the
Time-out, the washing pump
operates at maximum speed and
the alarm code is stored in
memory (the cycle continues)
The cycle continues until the next
phase without supplementary fills
and without heating. The error is
cancelled on completion of a drain
phase.
26/35
Possible causes
Heating element faulty; intervention of safety
thermostats (open); wiring faulty; NTC sensor (poor
thermal contact); insufficient water circulating in the
tub; washing pump faulty (impeller stripped); circuit
board faulty.
NTC sensor faulty; wiring short-circuited / open;
circuit board faulty.
Circuit board faulty.
Circuit board faulty
(configuration software incorrect).
Turbidity sensor faulty; sensor wiring faulty; circuit
board faulty.
Motor winding interrupted / short-circuited; motor
jammed (foreign bodies); wiring to washing motor
faulty; motor capacitor faulty; Tachymetric
generator interrupted / short-circuited; circuit board
faulty.
Dishes upside-down; central filter clogged;
excessive foam; leaks from the sump-pressure
switch coupling; pressure switch faulty / false
contacts.
599 35 90-23