Indicator Leds; Display; Options; In 1 Tablet - Electrolux Diva Service Manual

4.1.5

Indicator LEDs

The indicator LEDs provide the user with the following information:
End of cycle: this LED is featured on all models.
Salt: indicates that the salt reservoir is empty. If the level of regeneration is set to "1" (no regeneration),
this LED remains unlit at all times.
Rinse-aid: indicates that the rinse-aid reservoir is empty.
Delay time: LEDs LD7, LD8, LD9 provide a sequential indication of the time to elapse before a delayed
start (3-6-9 hours)
4.1.6

Display

The one-digit display, if featured, shows only the delay time at the start: at every pressure of the
corresponding button the time increases by one hour till max. 9 hours.
The functions of the various LEDs depend on the software configuration of each appliance.

4.2 Options

4.2.1

" 3 in 1 Tablet"

This option can be selected by pressing the corresponding button, and remains in memory until the same
button is pressed again. This option modifies the phases of the programme in order to optimize performance
when "3 in 1" detergent tablets are used:
variation of the duration of the programme and the temperatures required to dissolve the detergent
tablets.
reduction of water exchange (partial drain phases)
exclusion of introduction of rinse-aid
exclusion of regeneration / resin washing
4.2.2

Extra rinse (rinse +)

This option may be selected temporarily by pressing the button (if featured), or in "Service" mode. If this
option is set by the service engineer, it remains in memory until deactivated (see relative section).
This option adds one cold rinse (with pulse washing) with a duration of about 5 minutes.
4.2.3

"1/2 load"

The 1/2 load option optimizes the washing cycle when only a small load is placed in the appliance.
•
1/2 load button
When this button is pressed, certain parameters of the selected washing cycle are modified:
Exclusion of Pre-wash (if featured)
Reduction of the washing temperature
Reduction of the duration of the programme
•
Automatic ½ load
When this button is not featured on the control panel, certain programmes may feature automatic
detection of the half load. This system measures variations in the temperature during the initial heating
phase. The temperature and the duration of the wash are both reduced.
This option is not available in the following cycles: "Intensive", "Short 30 minutes", "Soak", "Heating
plates" and "Glassware".
4.2.4

"Sanitize"

This is a special option used to sanitize the dishes/cutlery. However, it is NOT compatible with the
"Glassware" programme.
During the final rinse, the temperature is maintained at 68°C for 10 minutes.
If used together with the SOAK option, the system performs a special sanitizing programme which lasts
approximately 46 minutes (1 hot rinse followed by 10 minutes at a constant temperature of 68°C)
SOI/TD PR 8/35 599 35 90-23