Setting Up the Digital Scanner
Installing the Interface Cable
Plug the interface cable modular connector into the cable interface port on the bottom of the digital scanner's
1.
base (see
Figure
Gently tug the cable to ensure the connector is secure.
2.
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
3.
connections).
Interface cable port
Clip
To host
Installing the Cable
Figure 1-2
NOTE Different hosts require different cables. The connectors illustrated in each host chapter are examples only.
Connectors vary from those illustrated, but the steps to connect the digital scanner are the same.
Removing the Interface Cable
Press the cable's modular connector clip through the access slot in the digital scanner's base.
1.
Removing the Cable
Figure 1-3
Carefully slide out the cable.
2.
1-2).
Interface cable modular
connector
Getting Started
1 - 3