Blade Installation - Partner K950 RING Operator's Manual

Blade Installation

NOTE: Partner offers a
selection of wet cutting ring
blades for different materials.
Check with a Partner dealer
for the blade that is best
suited for your application.
WARNING!
!
Never retip a used ring blade. A used blade
may not have the proper strength. A retipped
blade may crack or break and cause severe
personal injury to the operator or others.
• Wipe blade to remove any
debris from the blade
surface.
• Loosen the locknuts on the
support roller cover.
• Unscrew the adjusting
screws a few turns.
12
– English
SET UP AND ADJUSTMENTS
• Loosen the knobs to release
all spring tension.
• Remove the four screws
that fasten the support roller
cover with the 6 mm L-allen
wrench and remove the
cover.
• Put the blade on the
machine.
NOTE: The blade has a
machined groove on one
side which is the tracking
groove for the engagement
rollers.
• Next, insert the blade into
the drive disc. Rotate the
blade while installing it onto
the lower engagement
roller. If needed, push in
the engagement rollers, so
that the shoulders on the
engagement rollers enters
the groove on the blade.