Log Placement - Vermont Castings Resolution VHLDV500 Installation And Operating Instructions Manual

LOG pLaceMent

LOG pLaceMent
Burner Grate Assembly
1. Hold Log #1 with the flat side of the log
parallel to the right brick. Place the log on
the pin on the right rear of the log bracket.
Make sure to fit the notch in the front of
the log over the fettle. There should be a
slight gap (approximately 3/8") between
the log and the brick.
Log #2
20300293
LG753
VHLDV burner grate
Figure 36
LG755
Left front log #2
Figure 35
LG753
LG754
VHLDV right log #1
LG755
Figure 37
Resolution Direct Vent Gas Fireplace
Log #1
2. Hold Log #2 in your left hand with
the thick end to the left. Position the
log on the left front just behind the
fettle and seat the log on the two
(2) pins on the left fettle bracket.
The right end of the log should rest
along the back edge of the front
burner.
LG754
29