Display Layout For Models With Rf Controlled Hbtn; Basic Software Functionality; Motor Power Regulation And Led-Functionality - Electrolux Elara Service Manual

3.2 Display Layout for models with RF controlled HBTN:

3.2.1 Basic software functionality

- ON/OFF switch
- Soft-start
- Automatic 50/60Hz detection.
- When started from unplugged, cleaner starts in AUTO mode, otherwise in last used mode.
- Toggle between cleaning modes, 5 manual power steps.
- Power indication, "fading light". 6 light intensity levels for LED:s when running in auto.
- In manual mode, one LED per power level. LED1 in power step 1, LED2 in power step 2..
- AUTO lightened when function activated.
- S-bag and Filter status are indicated by two LED:s.
- Failure indication.

3.2.2 Motor power regulation and LED-functionality

1. Main plug connected:
- Motor shall be off.
- Power LED:s indicates standby by turning on each LED for 0,5 seconds each, "walking light".Order
should be from "Min" to "Max". AUTO LED showing continuous light, indicating next start in Auto.
2. First start by one of the On/Off switches (after main plug is connected):
- Motor power starts.
- Auto function activated, and indicated by LED:s.
- Power bar LED indicates actual power used according to ignition table by adjusting the intensity of
the power LED:s.
3. Auto button is pressed on the remote, when AUTO-function is activated:
- No change in function, AUTO-function shall still be activated.
4. Cleaner is in AUTO-mode, and "min/max" on the remote is pressed for the first time since main plug was
connected:
- AUTO-mode turns off.
- AUTO LED:s turns off.
- Motor runs to minimum power.
- Power LED indicates minimum power step (same power step split as for level 1).
5. Cleaner is in manual mode and "min/max"on the remote is pressed:
- Power steps up, same power split as for level 1 (5 manual power steps).
- If power step 1 (minimum power) the power changes to maximum power. (Power order shall be 1-
2-3-4-5-1-2-3-4-5-1 a.s.o. where 1 is minimum and 5 is maximum power).
- Actual power step is indicated by corresponding LED (same functionality as the power indication for
level 1).
6. Cleaner is in manual mode and turned off by one of the ON/OFF buttons:
EN Publication number 599 71 19-22 Rev. 01 02/2009 PR - 29/42