Electrolux Elara Service Manual page 30

- Motor turns off; last power setting and mode is remembered by the microcontroller.
- LED indication shows the last used power setting by flashing the corresponding LED with 1Hz,
same function as for level 1.
7. Cleaner is turned on by one of the On/Off switches after being at point 6:
- Motor turns on and run into manual mode, and starts at the last used power setting.
- LED indication shows used power setting, with continuous light.
8. Cleaner is in manual mode and AUTO switch on the remote is activated:
- Last manual power setting is remembered by the microcontroller.
- AUTO mode is activated, and power is adjusted according to that.
- Power bar starts to indicate power setting as in point 2.
- AUTO LED:s is activated.
9. Cleaner is in AUTO-mode, and "min/max" on the remote is pressed after being at point 8:
- AUTO-mode turns off.
- AUTO LED:s turns off.
- Motor runs to last manual used power..
- Power LED shows used power setting, with continuous light.
10. Cleaner is in AUTO-mode, turned off by one of the On/Off switches after being at point 8:
- Motor turns off.
- Power LED:s indicates standby by turning on each LED for 0,5 seconds each, "walking light". Order
should be from "Min" to "Max". Same as for point 1.
- AUTO LED showing continuous light, indicating next start in AUTO.
EN Publication number Rev. 01
599 71 19-22
02/2009 PR - 30/42