Fault Alarm; Control Panel Beeps - Fisher & Paykel RB90S Installation Instructions And User Manual

Fault Alarm

If the electronic controller detects a fault which may affect operation, an alarm
will sound and the fault icon on the display panel will flash. The audible alarm
will stop when any button is pressed but the lights will continue flashing.
If such a fault occurs, contact our Customer Care Centre immediately; the fault alarm sound will
help the service person find and remedy the cause of failure.
Important!
Your CoolDrawer is designed to operate for many years without the need for service checks.
However, if your CoolDrawer is malfunctioning contact our Customer Care Centre, details of
Customer Care can be found in the back of this Guide. All electrical repairs must be carried out by
an adequately trained service technician or qualified electrician.

Control panel beeps

The control panel beeps can easily be silenced, if you prefer quiet operation.
To turn control panel beeps on or off:
Press the LOCK
Press and hold the LOCK
icon turns off or on.
Drawer alarms
If the drawer is left open an alarm will sound after 60 seconds.
■ ■
If the drawer remains open, subsequent beeps will sound every 30 seconds until the drawer
■ ■
is closed.
After 5 minutes of the drawer being opened, the alarm will sound continuously and the
■ ■
compartment light will turn off.
General operating instructions
button for 3 seconds to unlock the control panel.
and COLDER buttons for 4 seconds until the beep
27