Phonic Powerpod 740 User Manual page 6

Master Section
4. Tape In (L and R)
The first of these inputs accommodates RCA cables from such
devices as tape and cD players. In addition to these inputs,
however, Phonic has incorporated a mini stereo jack for the
inclusion of such devices as mini disc (MD), portable cD, and MP3
players (such as the apple iPod), as well as laptop computers. The
line from this feed is directed to the Tape In mixing bus, before
being fed through to the Main l/R mixing bus.
5. Record Outputs (L and R)
as with the Tape In ports, these outputs will accommodate Rca
cables, able to be fed to a variety of recording devices. also, similar
to the Tape In ports, included are mini stereo jacks for the addition
of recording devices such as MD players and laptop computers.
a trim control is featured on these outputs to accommodate for
devices with different recording levels.
6. AUX Inputs
These TS inputs (which are mono inputs on the Powerpods 620,
740 and 780 Plus; stereo on the Powerpod 1062 Plus and 1082
Plus) connect the mixer with parallel external devices, such as
sub mixers or external effect processors, receiving the processed
signal from another source and feeding it to the aUX mixing buses.
The stereo aUX inputs (featured on the Powerpod 1062 and 1082
Plus only) can be used as monaural inputs by simply plugging the
device's 1/4" phone jack into the left (mono) stereo input and leave
the right input bare. Your good friend, Jack Normalizing, will take
care of the rest.
6
7. Foot Switch Jack
This port is for the inclusion of a non-latching foot switch, used to
remotely adjust properties of the built-in Digital Effect processor.
The Powerpods 620, 740, 780, 1062 and 1082 Plus all feature a
single foot switch jack, which allows the user to remotely turn on
and off the digital effects.
7
6
4 5
8
POWERPOD 620
8. EFX (Effect) Outputs
These 1/4" TS outputs are the final output from the EFX send
mixing bus. This feed may be used to connect to an external digital
effect processor, or even to an amplifier and speakers, depending
on your desired settings.
9. Monitor Outputs
These 1/4" TS outputs are the final output from the Monitor send
mixing bus. This feed may be used to connect to an amplifier and
speaker. Feeding the output from the Monitor out to an amplifier
(and possibly an equalizer) and then to a floor monitor speaker
allows artists to monitor their own instruments or vocals whilst
performing, or an engineer to monitor the mix.
10. Main Outputs
These jacks will output the final stereo line level signal sent from
the main mixing bus. The primary purpose of these jacks is to
send the Main output to external devices that may run in parallel
with the mixer. This may include additional power amplifiers,
mixers, Pa systems, as well as a wide range of other possible
signal processors. Powerpods 620, 740 and 780 Plus all feature
monaural main outputs, where the Powerpod 1062 and 1082 Plus
feature stereo main output jacks.
9
11. Power Amp Inputs (Powerpod 1062 and 1082 Plus Only)
These inputs support 1/4" TS plugs and can be used for the
inclusion of an external line level stereo signals to the built-in
power amplifier. If a device is connected to the power amp inputs,
the main feed will automatically bypass the power amp and the
inserted feed will be amplified and sent to the Speaker Outputs
instead.
11
/ 740 / 780
10
/ 1062 / 1082