Drain Pump - GE WSSH300G Technical Service Manual

Like the detergent channel, when the flow of the incoming
water is more than the holes can dispense, the excess
water backs up into the channel across the rear of the
dispenser and flows into the tub.
For water to enter the fabric softener channel, both the
left and right inlets must be activated. As the water
from the left inlet passes over the channel, it collides
with the water from the right inlet. This collision changes
the water path directing it to the front of the cavity and
into the fabric softener channel. The fabric softener
channel forms a loop that allows the water to pass over
the fabric softener cavity section of the drawer.
As the water passes over the fabric softener section,
holes in the cavity allow some of the water to enter and
mix with the fabric softener.
This raises the mixture level above the tubes in the drawer
fabric softener cavity allowing the mixture to flow into the
tub. Like the detergent channel, when the flow of the
incoming water is more than the holes can dispense,
the excess water backs up into the channel across the
rear of the dispenser and flows into the tub.

Drain Pump:

The drain pump is mounted to the bottom plate of
the washer behind the access panel. It operates on
120 VAC and is controlled by the control board and
pressure switch. The pump out specifications of the
drain pump vary from 12 G.P.M with a 3 foot
standpipe height to 7 G.P.M. with an 8 foot standpipe
height.
20