Component Resistance Chart; Water Fill Height; Electrical Requirements; Incoming Water Pressure - GE WSSH300G Technical Service Manual

QUICK REFERENCE SHEET

Component resistance chart.

Water level
Water fill height 4 ± .5 "
No load, start position of permanent press cycle.

Electrical requirements.

Incoming water pressure.

Drain requirements.

Motor.

Electrical component
Dispenser valve solenoids
Door lock solenoid
Pump motor
NTC thermistor
M1 TO M2
M2 TO M3
Motor
M1 TO M3
M4 TO M5
Circuit - Individual, properly polarized and grounded
15 amp. branch circuit fused with 15 amp. time
delay fuse or circuit breaker.
30 and 120 pounds per square inch (maximum
unbalance pressure, hot vs. cold, 10 psi.)
Drain capable of eliminating 17 gals (64.3 L) per
minute.
A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
The standpipe height above the floor should be:
Minimum height:
Maximum height:
No load agitate wattage - Max 150
No load spin wattage - Max 550
6
Resistance Ω
@ 77°F (25°C)
800 ± 7%
1325 ± 10%
12 ± 7%
3K - 163K
5.3 ± 7%
5.3 ± 7%
5.3 ± 7%
118 ± 7%
24 in. (61 cm)
96 in. (244 cm)