Removing The Large Pulley; Removing The Drive Motor - GE WSSH300G Technical Service Manual

Removing the large pulley:

1. Disconnect the washer from the electrical supply.
2. Remove the rear access panel and the belt.
3. Using a #6 mm allen wrench, remove the bolt in the
center of the pulley by holding the pulley and
turning the wrench counterclockwise.
4. Work the pulley back and forth to remove it from
the shaft.

Removing the drive motor:

1. Disconnect the washer from the electrical supply,
remove the rear access panel and the belt.
2. Disconnect the electrical plug and the ground
wire from the motor.
3. Using a 5/16" socket, remove the (4) bolts, two
in the front and two in the rear, that secure the
motor to the outer tub.
49