Pride Mobility JET 3 Owner's Manual page 19

NOTE: If you still get "ripple up and down of lights", contact
your authorised Pride provider.
NOTE: When the batteries approach a discharged state, the
first red light will begin to slowly flash, reminding you the
batteries need to be charged immediately!
SPEED/PROFILE KEYS
There are two keys that control either the speed or the profile. See figure
21. This depends on how your VSI was programmed. Press the speed/
profile increase key to increase the speed or change the profile. Press
the speed/profile decrease key to decrease the speed or change the
profile. The speed/profile setting is displayed in the maximum speed/
profile indicator. If your power chair was programmed with a drive profile,
contact your authorised Pride provider for more information.
NOTE: We recommend that the first few times you operate
your power chair, you set the speed to the slowest setting
until you become familiar with your new power chair.
ACTUATOR KEY AND ACTUATOR LIGHTS (FOR OPTIONAL EQUIP-
MENT)
Actuator keys and actuator lights are used for optional equipment such
as power elevating seats or power elevating leg rests. See figure 21. For
specific operation of the actuator keys and actuator lights, contact your
authorised Pride provider.
HORN KEY
The horn key activates the horn. See figure 21.
OFF-BOARD CHARGER/PROGRAMMING SOCKET
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front of the VSI.
See figure 20. If you use an off-board charger, the charger current should not exceed 12 amps. Contact your authorised Pride
provider for more information.
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/program-
ming socket. See your authorised Pride provider for more information.
NOTE: The socket may also be used for reprogramming the VSI. Contact your authorised Pride provider for
more information.
CONTROLLER CONNECTOR
This connects the VSI to the power chairís batteries, motors, and motor brakes. See figure 20.
3-PIN CHARGER INHIBIT CONNECTOR
This connects the VSI to the onboard battery charger. See figure 20. This connection provides an inhibit that disables the VSI
when the battery charger is on. The charger inhibit connector is coded with colored dots. The dots are positioned so that you
align the flat side of the male connector with the flat side of the female connector before making the connection.
CAUTION! Failure to properly align the connectors can result in damage to the VSI, the charger harness, and
the connectors.
UK Jet 3/Rev B/Dec02
Figure 21. VSI Controller Keypad
www.pridemobility.com 19