Joystick/Controller Position; Footrest Angle; Footrest Height - Pride Mobility JET 3 Owner's Manual

HEIGHT ADJUSTMENT
HEIGHT ADJUSTMENT BOLT
BALL DETENT PIN
Figure 17. Footrest Height and Depth Adjustment

JOYSTICK/CONTROLLER POSITION

You can position the joystick/ controller for either left-hand or right-hand use.
To change the joystick position:
1. Disconnect the controller and charger harness connectors. See figure 4.
2. Cut the tie-wrap that attaches the controller cable to the armrest. See figure 15.
3. Use a 5-mm hex key to loosen the setscrew. See figure 14.
4. Slide the joystick mounting bracket out of the armrest.
5. Loosen the setscrew in the other armrest.
6. Place the joystick mounting bracket in the other armrest.
7. Tighten the setscrew in each armrest.
8. Connect the controller cable to the armrest with a new tie-wrap. See figure 15.

FOOTREST ANGLE

You can adjust the angle of the footrest with a 5-mm hex spanner. See figure 16.
To adjust the footrest angle:
1. Turn the setscrew clockwise to lower the front of the footrest.
2. Turn the setscrew anticlockwise to raise the front of the footrest.

FOOTREST HEIGHT

The footrest height is easily adjusted to any one of six different heights. See figure 17.
To raise or lower the footrest:
1. Remove the height adjustment bolt from the footrest using a 6-mm hex key and 13-mm socket. See figure 17.
2. Raise or lower the footrest to the desired height.
3. Reinstall the bolt into the footrest.
To adjust the anti-tip wheel height:
1. Remove the seat, the body shroud, and the batteries.
2. Locate the jam nut and bolt on the anti-tip assembly. See figure 22.
UK Jet 3/Rev B/Dec02 www.pridemobility.com 15