Installation Instructions - Moen PureTouch 87810 Owner's Manual

INSTALLATION INSTRUCTIONS

CAUTION:
Always turn water supplies OFF before removing existing faucet. Turn
faucet on to relieve water pressure and to ensure water is completely off.
OLD FAUCET REMOVAL: Your old faucet may attach in a number of different
ways depending on the brand. To remove, reverse steps in installation
instruction sheet of old faucet, follow instructions in a DIY type of book or
follow instructions listed below.
After years of use, you may need to use a penetrating oil spray on the faucet
mounting hardware to help loosen corrosion and assist in removing the faucet
connections.
Disconnect water supply lines from faucet supply lines. Remove mounting
hardware using a basin wrench or channel lock pliers. Lift out faucet.
Thoroughly clean and dry the mounting surface after removal of old faucet.
INSTALLING PURETOUCH
Helpful Tools: Phillips screwdriver, adjustable wrench (2)
CAUTION: Do not use with portable washing devices, i.e.
dishwashers, washing machines.
NOTE: Do not bend supply tubes until instructed in step 5.
1. Place screen washer (17) in hose connection (16) and
attach to pull-out spout (19). A few threads on the
quarter turn connector (18) will be showing.
2. With the spout receptor (14) facing directly forward
and threaded discharge tube (15) in back, feed
small end of hose (37) down through spout receptor.
When encountering resistance, feed the hose
through with a push/pull motion. Set aside faucet
assembly.
Depending on your sink configuration, you have
the option to install your faucet with a deck plate (26)
or a round deck ring (28). NOTE: Never use deck
plate (26) and deck ring (28) together on one sink.
3a.FOR INSTALLATION USING DECK PLATE.
Be sure mounting area is clean and dry. Thread deck
plate studs (30) into deck plate and hand tighten.
Place rubber deck gasket (27) over the deck plate
studs and onto the deck plate.
Assemble clamp bars (31) (open side toward deck
plate), spacers (32), and small mounting nuts (33) to
studs as shown (do not tighten). (NOTE: for decks
thicker than 3/4" remove deck plate spacers.) Tilt clamp bars
back, then place mounting studs with hardware attached down
through deck holes making sure that deck plate is centered
on sink and hand tighten. Carefully trim excess deck gasket.
5
FILTERING FAUCET SYSTEM
®
HELPLINE: 1-800-BUY-MOEN
(1)
(2)
(3a)
(3a)
INS139