Table of Contents
Advertisement
Electrical Principle (Applicable to UF1130)
LED
3.3VDC
Controller
-4.5VDC
Reset
Installation Instructions
Installation Preparations
1. Professional installer shall prepare installation tools
and necessary qualified inspection instruments. See "
recommended tools" on the home page for details.
2. Check whether the water purifier is in good condition
and whether the attached documents and accessories
are complete.
3. Read the operation manual carefully to understand
the function, use, installation requirements and
installation methods of the ultrafiltration water
purifier to be installed
4. Incoming water quality reach require from GB5749
Municipal tap water regulation
5. Use a pressure gauge to check the water pressure of
the water pipe. The water inlet pressure should be
within the range of 0.1 ~ 0.4MPa. If it is lower or higher
than this range, a booster pump or pressure reducing
valve should be installed.
6. Assist the user to select the installation location of
ultrafiltration water purifier.
or have strong corrosive gas environment.
rain.
to leave a certain space for future repair,
maintenance and replacement of the filter element.
not be less than 4-times the total mass of the
water purifier after being filled with water.
7.Close first water valve before installation.
7
Advertisement
Table of Contents
