Moen PureTouch 87810 Owner's Manual page 8

8. Counterweight (38) is designed to snap together onto the
spout hose. To disassemble counterweight, depress tabs
and pull halves apart, or pry halves apart with flat-head
screwdriver. Assemble counter weight at the bottom of the
spout hose loop. Align tabs on each half of the
counterweight with the slots on the other half of the
counterweight. Squeeze halves together until they snap
together. Counter weight should not slide on the hose.
CAUTION: Severe bends of the supply tubes may cause
crimping. Restricted water flow could result.
9. CAREFULLY bend the supply tubes
and align with water supply lines. DO
NOT KINK SUPPLY TUBES. Connect
your water supply lines to threaded
fittings (24) (using tailpiece nuts (25)
if necessary). Hot water supply tube is
the longer tube (on left). Hold
threaded fitting with a wrench to
prevent twisting and collapse of the copper tube while tightening with
another wrench.
10.Pull pullout spout in and out to check for free movement of hose. If needed,
adjust the placement of weight to aid the clearance of the hose.
11.Faucet flushing is required before installation is complete. (See below)
FLUSHING INSTRUCTIONS
IMPORTANT: Pipe chips, sand, stones and other solids found in new and
renovated plumbing can damage the sealing surfaces of the filter cartridge and
cause a leak. To avoid damage, DO NOT TURN ON SUPPLY VALVES until
instructed below.
1. Pull hose out of spout receptor, tie a dish towel around the hose to keep it
from slipping back into the spout receptor.
2. Unscrew the hose from the bottom of the quarter turn connector (18) and
remove screen washer (17). Turn on supply valves. Direct hose into sink, then
turn the faucet on in the full cold position (handle pointing to the right) to
turn on the cold water supply for 15 seconds.
3. Leaving the handle in the open position, turn to the full hot position (handle
pointing to the left) and turn on the hot water supply for 15 seconds.
4. Place handle in the closed position. Remove the quarter turn connector (18)
from pullout spout and reassemble with screen washer (17) to hose. Do not
reassemble pullout spout to quarter turn connector since MicroTech filter
installation is required. Check under the sink for system leaks.
7 HELPLINE: 1-800-BUY-MOEN
(9)
INS139