Battery Replacement - Moen PureTouch 87810 Owner's Manual

BATTERY REPLACEMENT

Helpful Tools: large flat tip screwdriver, small Phillips screwdriver (#1)
1. With faucet off, push filtered water button and
record percentage of remaining usable filter life.
When battery is changed, filter life indicator
automatically resets to 100%. Record here _____
2. Remove pullout spout (19) from receptor (14)
and tie a dishtowel around the hose to keep it
from slipping back into the spout receptor.
3. Disconnect the quarter turn connector (18) from
spout by turning it counterclockwise one quarter
turn. The quarter turn connector will remain
attached to the hose.
4. Remove filter cover by lifting up and away from
pullout spout. Remove filter cartridge from
pullout spout by lifting from the inlet tube, using
same up and away motion. NOTE: Excess water may
dribble from cartridge and valving. Dry pullout spout
with towel.
5. With large flat screwdriver or dime, unscrew
(counterclockwise) and remove filter outlet nut (20).
6. With Phillips screwdriver unscrew (counterclockwise)
and remove two short lower housing screws. Carefully
remove lower housing cover.
7. Unscrew (counterclockwise) and remove three upper
housing screws. Carefully lift upper housing cover
off of wand appliance leaving rubber button covers
in place.
8. Battery should now be exposed on upper side of
spout. Remove old battery from battery
compartment and dispose of properly.
9. Install new 2032 battery with positive side
(+) up. When battery is properly installed,
filter life indicator will light momentarily. Activate
electronic indicator by pressing filtered water
button to ensure proper battery installation. Display
should be visible.
10.Reinstall upper housing cover by carefully aligning
over button covers.
11 HELPLINE: 1-800-BUY-MOEN
ELECTRONIC
(1)
INDICATOR
(3)
(4)
(5 & 14)
(6 & 13)
(6 & 12)
UPPER HOUSING
SCREWS
(7 & 11)
(7 & 10)
cont'd
FILTERED
WATER
BUTTON
FILTER COVER
LONG SCREW
INS139