Filter Replacement Instructions - Moen PureTouch 87810 Owner's Manual

FILTER REPLACEMENT
MicroTech™ replacement filter cartridges may be purchased at the same
location as the faucet. For the dealer nearest you, call 1-800-BUY-MOEN. Use
only MicroTech filter cartridges with the PureTouch
Do not remove the filter until it is to be replaced.
1. Remove pullout spout (19) from receptor (14)
and tie a dish towel around the hose to keep it
from slipping back into the spout receptor.
2. Disconnect the quarter turn connector (18) from
pullout spout by turning it counterclockwise
one quarter turn. Quarter turn connector will
remain on the hose.
3. Remove the filter cover by lifting it up and away
from the pullout spout. Remove the filter by
lifting it up and away from the pullout spout.
NOTE: Excess water may dribble from cartridge
and valving.
4. Using soft towel or cloth, wipe excess water
from wand appliance.
5 Insert the new filter by aligning the two outlet
tubes on the filter with the two inlet ports of
the spout body and gently pressing in and
down. Upon successful installation of the filter
cartridge, the filter life indicator will beep
three times and will reset automatically.
6. Reinstall the filter cover by positioning the
alignment tab with the corresponding notch in
the pullout spout body and gently pushing in
and down.
7. Reattach the filtering pullout spout to the hose
by aligning the dots on the quarter turn
connector (18) and the pullout spout (19). Push
the quarter turn connector onto the pullout
spout and turn it clockwise locking it in place.
8. Allow water to run through the new filter for 5
minutes to flush out any loose carbon particles.
After these small black particles are washed out the filter is ready to be used.
13 HELPLINE: 1-800-BUY-MOEN
Filtering Faucet System.
®
(2)
(3)
ALIGN
DOTS
FILTER COVER
(6)
(7)
INS139