Lubrication And Maintenance; Air Supply And Connections - King Canada 8260FSN-2 Instruction Manual

THE FOLLOWING ILLUSTRATION SHOWS THE CORRECT MODE OF CONNECTION TO THE AIR
SUPPLY SYSTEM WHICH WILL INCREASE THE EFFICIENCY AND USEFUL LIFE OF THE FLOORING STAPLER/NAILER.
LUBRICATION

AIR SUPPLY AND CONNECTIONS

LUBRICATION AND MAINTENANCE

• Your flooring stapler/nailer needs to be lubicated before and after the first time you use it.
• Disconnect the air supply from the flooring stapler/nailer before lubricating.
• Turn the flooring stapler/nailer so that the inlet is facing up and put ONE DROP of high speed spindle
oil or oil without detergent into the air inlet. Never use detergent oil or additives. Operate the flooring
stapler/nailer briefly after adding oil.
• Wipe off excessive oil at the exhaust. Excessive oil will damage O-rings of the flooring stapler/nailer. If
an in-line oiler is used, manual lubrication through the air inlet is not required on a daily basis.
AIR SUPPLY AND CONNECTIONS
Air hose Quick
connector
Quick couplers
Quick connector
• Many air tool users find it convenient to use an oiler to help provide oil circulation through the tool and
it increases the efficiency and useful life of the tool. Check oil level in the oiler daily.
• Many air tool users find it convenient to use a filter to remove moisture and impurities which can rust
or wear internal parts of the tool. A filter also increases the efficiency and useful life of the tool. The
filter must be checked on a daily basis and, if necessary, drained.
• For better performance, install a 3/8" quick connector (1/4" NPT threads) with an inside diameter of
.315" on your tool and a 3/8" quick coupler on the air hose.
WARNING!
Filter
Oiler
Regulator
Compressor