Related Manuals for King Canada 8201NL
Summary of Contents for King Canada 8201NL
- Page 1 18 GA. X 2” BRAD NAILER MODEL: 8201NL INSTRUCTION MANUAL COPYRIGHT © 2020 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty Information
Please keep your dated proof of purchase for warranty and servicing purposes. REPLACEMENT PARTS Replacement parts for this product are available at our authorized King Canada service centres across Canada. Please use the 10 digit part numbers listed in this manual for all part orders where applicable. -
Page 3: Specifications
Magazine Safety release Nail loading area Nail discharge area SPECIFICATIONS Model......................................8201NL Air inlet ......................................1/4” NPT Compressed air: Maximum permissible operating pressure ........................120 PSIG (8.3 bar) Recommended operating pressure range ..........................60-100 PSI Nail range ..........................3/4” to 2” 18 Ga. brad head finish nails Width ......................................1.25mm... -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS • Read and understand this manual and all the safety instructions before operating this nailer. If you have any questions, please contact our authorized service centres or retailers for help. • Never allow the use of flammable gases as a power source for the nailer. Use filtered, lubricated and regulated compressed air only. -
Page 5: Lubrication And Maintenance
LUBRICATION AIR SUPPLY AND CONNECTIONS LUBRICATION AND MAINTENANCE • Your nailer needs to be lubricated before and after the first time you use it. • Disconnect the air supply from the nailer before lubricating. • Turn the nailer so that the inlet is facing up and put ONE DROP of high speed spindle oil or oil without detergent into the air inlet. - Page 6 FIRING MODE & VERIFICATION Sequential Mode In sequential mode, the nailer is actuated by depressing the nailer nose against the work surface, the trigger then needs to be pulled and released each time a nail is driven. OPERATING A CONTACT SAFETY TRIP NAILER (SEQUENTIAL MODE): •...
-
Page 7: Clearing Jams
LOADING NAILER & CLEARING JAMS LOADING NAILER MAGAZINE • Disconnect the air hose from the nailer air inlet. • Depress the magazine latch, pull back on the magazine cover. • Insert a stick of nails into the magazine. Make sure the pointed ends of the nails are as close to the bottom edge of the magazine as possible, ensuring the head of the nail is aligned with the appropriate machined groove in the magazine. - Page 8 OPERATING YOUR NAILER OPERATING YOUR NAILER WARNING! Protect your eyes and ears. Wear Z87 safety glasses with side shields. Wear hearing protection. Employers are responsible for ensuring the user or anyone near the nailer wears the above mentioned safety protection. WARNING! Check and replace any damaged or worn components.
-
Page 9: Maintenance And Troubleshooting
Accessory Kit is available for your Nailer (model: KW-169). Contact your local King Canada distributor for more information. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list. KW-169...