Please keep your dated proof of purchase for warranty and servicing purposes. REPLACEMENT PARTS Replacement parts for this product are available at our authorized King Canada service centers across Canada. Please use the 10 digit part numbers listed in this manual for all part orders where applicable.
Magazine Feeder shoe Nail discharge area SPECIFICATIONS 28º Framing Nailer Model......................................8228N Air inlet ......................................1/4” NPT Compressed air: Maximum permissible operating pressure ........................125 PSIG (8.6 bar) Recommended operating pressure range......................70-120 PSI (4.8-8.3 bar) Nail range ..................2-3/16” to 3-9/16” from 10-1/4 to 11-1/2ga. clipped head 28º nails Nail diameter range................................0.113”...
SAFETY INSTRUCTIONS • Read and understand this manual and all the safety instructions before operating this nailer. If you have any questions, please contact our authorized service centres or retailers for help. • Never allow the use of flammable gases as a power source for the nailer. Use filtered, lubricated and regulated compressed air only.
LUBRICATION AIR SUPPLY AND CONNECTIONS LUBRICATION AND MAINTENANCE • Your nailer needs to be lubicated before and after the first time you use it. • Disconnect the air supply from the nailer before lubricating. • Turn the nailer so that the inlet is facing up and put one drop of high speed spindle oil or air tool oil without detergent into the air inlet.
Page 6
GENERAL GUIDE TO SETTING UP YOUR FRAMING NAILER OPERATING YOUR NAILER WARNING! protect your eyes and ears. Wear Z87 safety glasses with side shields. Wear hearing protection. Employers are responsible for ensuring the user or anyone near the nailer wears the above mentioned safety protection.
OPERATION AND ADJUSTMENTS Set-up & Loading nails into the magazine Warning! Disconnect the air hose from the nailer air inlet. 1) Pull the feed shoe all the way to the rear, until it latches. See Fig.1. 2) Orient the strip of nails with points down and drop the nails into the magazine. 3) Slide the nails forward in the magazine.
• Magazine or nose screws are loose. • Screws need to be tightened. • Damaged driver. • Replace driver. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.