Reassembling the Optical Drive
NOTE: The small arrow shown on the metal bracket indicates the top side of the optical
bracket. Keep this in mind when removing or installing the drive.
To reassemble an optical drive, follow the steps below and refer to the figure in the preceding
section.
1. Position the optical drive bracket plate so that it is aligned with the rear panel of optical drive.
2. Secure the optical drive bracket plate with silver M2.0×2.5 screws.
3. Install the optical drive module into the bay as described in the preceding section.
Tecra A6 Maintenance Manual
[CONFIDENTIAL]
4 Replacement Procedures
4-21