Advertisement
1.1.4 Disconnection of Connectors (Wires)
Connector
Pull both ends of the connector in the arrow direction, re-
move the lock and disconnect the flat wire.
Flat wire
Connector 1
Fig. 1-1-1 Connector 1
Flat wire
Connector 2
Fig. 1-1-2 Connector 2
Extend the locks in the direction of the arrow for unlocking
and then pull out the wire. After removing the wire,
immediately restore the locks to their original positions
because the locks are apt to come off the connector.
Flat wire
Connector 3
Fig. 1-1-3 Connector 3
B-B connector
Pull the board by both the sides in the direction of the arrow
for disconnecting the B-B connector.
Fig. 1-1-4 Connector 4
1.2 TOOLS AND EQUIPMENTS REQUIRED FOR
1.2.1 Tools required for adjustments
1
3
1.3 DISASSEMBLY/ASSEMBLY OF CABINET PARTS
1.3.1 Disassembly flow chart
The following flow chart shows the steps for disassembling
the cabinet parts. To assemble, perform the steps of the flow
chart in the reverse order.
Note: The encircled numbers indicate the order for disas-
Connector 4
ADJUSTMENTS
Torque driver
2
YTU94088
Connector catcher
4
YTU94036A
sembling the cabinet parts.
The screw numbers indicate the disassembling order.
FRONT CASE
1
REAR CASE
2
OPERATION UNIT
3
STROBE BOARD ASSEMBLY
4
JACK BOARD ASSEMBLY
LCD MODULE
5
MAIN BOARD ASSEMBLY
6
MONI/REG BOARD ASSEMBLY
OP UNIT
7
Clip IC replacement jig
PTS40844-2
Soldering kit
YTU96016B
1-2
Advertisement
