Proper Placement And Clearance Of Grill; Grill Installation Codes; Safety Precautions - Kenmore 122.33492410 Use & Care Manual

Precautions
WARNING
!
Failure to comply with these instructions could result in a
fire or explosion that could cause serious bodily injury,
death, or property damage.
WARNING
!
Your grill will get very hot. Never lean over the
cooking area while using your grill. Do not touch
cooking surfaces, grill housing, lid or any other grill
parts while the grill is in operation, or until the gas grill
has cooled down after use.
Failure to comply with these instructions may
result in serious bodily injury.
!
WARNING
1. Do not store or use gasoline or other
flammable liquids or vapors in the
vicinity of this or any other appliance.
2. An LP cylinder not connected for use
shall not be stored in the vicinity of this
or any other appliance.
DANGER
!
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.

Grill Installation Codes

The installation must conform with local codes or, in the
absence of local codes, with either the national fuel gas
code, ANSI Z 223.1/NFPA S4, Natural gas and propane
installation code, CSA B149.1, or propane storage and
handling code, B149.2, or the standard for Recreational
vehicles, ANSI A 119.2, and CSA Z240 RV series
recreational vehicle code, as applicable.
LP gas grill models are designed for use with a
standard 20 lb. Liquid Propane Gas tank, not included
with grill. Never connect your gas grill to an LP gas tank
that exceeds this capacity.
A tank of approximately 12 inches in diameter by 18-1/2 inches
high is the maximum size LP gas tank to use.
You must use an OPD gas tank which offers an Overfill
Prevention Device.
This safety feature prevents the tank from being overfilled
which can cause malfunction of the LP gas tank, pressure
regulator and/or grill.
The LP gas tank must be constructed and marked in
accordance with specifications of the U.S. Dept. of
Transportation (DOT). In Canada, the LP gas tank must meet
the National Standard of Canada ,CAN/CSA-B339 , Cylinders ,
spheres and Tubes for Transportation of Dangerous Goods
and Commission .
1. The LP gas tank must have a shutoff valve, terminating in an
LP gas supply tank valve outlet, that is compatible with a Type
1 tank connection device. The LP gas tank must also have a
safety relief device that has a direct connection with the vapor
space of the tank.
2. The tank supply system must be arranged for vapor
withdraw.
3. The LP gas tank used must have a collar to protect the tank
valve.

Proper Placement and Clearance of Grill

Never use your gas grill in a garage, porch, shed, breezeway
or any other enclosed area. Your gas grill is to be used
outdoors only, at least 24 inches from the back and side of
any combustible surface. Your gas grill should not be used
under overhead combustible construction . Do not obstruct the
flow of ventilation air around the gas grill housing.
• Do not install this outdoor gas grill in or on recreational
vehicles or boats
• Keep outdoor gas grill area clear and free from combustible
materials, gasoline and other flammable vapors and liquids
• Do not obstruct the flow of combustion and ventilation air.
Check for this each time prior to using grill.
• Never connect an unregulated LP gas tank to your gas grill.
The gas pressure regulator assembly supplied with your gas
grill is adjusted to have an outlet pressure of 11" water column
(W.C.) for connection to an LP gas tank.
• Only use the pressure regulator and the hose assembly
supplied with your gas grill. Replacement pressure regulators
and hose assemblies must be those specified in this manual.
3