Searing Side Burner Shelf Assembly; Close Grill Head Lid - Kenmore 122.33492410 Use & Care Manual

8. Searing Side Burner Shelf Assembly

a. Remove grate from searing side burner shelf and
set aside. Open Grill Head Lid. Loosen but do not
remove the two screws on the outside surface of the
Grill Head. Place the slotted holes on searing side
burner shelf over the two screw heads and drop down.
Do not tighten screws until end of next step.
b. Use two 1/4" x 15 mm screws (BB) to attach side
burner shelf to Grill Head from Grill Head inside. Use
these two screws in front and rear holes. Use one 1/4"
x 8 mm screw (FF) screw to attach side burner to Grill
head in the center hole. Use one 1/4" x 15 mm screw
(BB) and one 1/4" flat washer (EE) to attach the side
burner shelf front panel to the main control panel.
Tighten the two screws loosened in previous step.
c. Close Grill Head Lid. Remove the screw fastening
the ignition electrode to the front of the side burner
shelf and remove electrode. Remove the two
screws fastening the searing burner to the side
burner shelf and remove searing burner.
17