Smoke hollow SH7000 Assembly & Operation Manual page 21

OPERATING INSTRUCTIONS
CARE AND CLEANING
! WARNING !
Do not do any cleaning or maintenance on any grill parts until all parts are cool! Be sure
●
that the valve on the LP Gas Cylinder is closed and in the OFF position
After every cooking session, you may run the gas grill on HIGH, or set the Charcoal
●
Coals into the HIGH position to burn off any food residue, keeping the residue from build-
ing up.
CLEANING
Use only mild dishwashing detergents, hot water, a nylon scrub pad and a BBQ wire
●
brush cleaning tool
Always rinse all surfaces thoroughly after cleaning
●
Handle Porcelain coated surfaces gently and carefully- they are made from high tempera-
●
ture glass and can chip easily
Note: Grease Drip Trays and Grease Cup should be emptied and cleaned after each
●
use to prevent flare – ups and /or grease fires.
Burners
1. Turn the gas OFF at the LP Gas Cylinder and the burner control knobs
2. Lift off the cooking grids and the heat tents covering the burners
3. Remove the screw attaching the burners at the back of the grill
4. Gently and carefully, tilt the back of the Burner up and slide it backwards off the valve ori-
fice, then lift out of the grill
5. Wipe clean the orifice face
TROUBLE SHOOTING THE GAS GRILL
Burner does not light :
1. Check if LP Gas Cylinder is empty?
2. Check Igniter wire – is there a spark?
3. Check for spider webs or insect nests inside, clogging the Burner
Flame color is Yellow, should be Blue:
1. Check for spider webs or insect nests inside, clogging the Burner
2. Close Lid and run on HIGH to burn off residue on Burner
Flame flares up:
1. Cooking temperature is set too high
2. Food being cooked is too fatty
3. Grease has accumulated in the grill. Clean and burn off
21