Table of Contents
Advertisement
7. A SAFE LOCATION FOR THE HEATER:
Caution:
The main application of this heater is to pro-
vide radiant heat comfort in the outdoors, at
poolside, spa areas, terraces, patios and work
areas, etc.
It is necessary to provide "wind breaks",
against wind and breezes to maximize com-
fort.
NOTE : This heater is approved for outdoor use only:
Always maintain minimum clearances to combustibles as shown in figure 12 below.
Install heater on a level, solid and stable surface.
Do not install in an explosive environment. Keep away from areas where gas vapours
are present or inflammable liquids are stored or used.
In case of high winds, completely shut-off the heater and gas valve. Remove reflector
dome if necessary
7. 1 CLEARANCES FROM COMBUSTIBLES
The clearances to combustibles represent a sur-
face temperature of 90F° (50C°) above ambient
temperature.
It is the installer's responsibility to ensure that ma-
terials with a low heat tolerance which may de-
grade at lower temperatures are protected to pre-
vent degradation.
Maintain clearances as shown:
Sides of Reflector: 24 inches
Above Reflector:
Below Reflector:
:
18 inches
24 inches
Page 9
If objects are left under a heater in operation,
such objects will be subject to radiant heat.
Always maintain at least the minimum certi-
fied clearances to combustibles from the
heater to any adjacent combustible materials.
Refer to Fig 12 below.
Fig. 12
24"
24"
18"
24"
4SN/L5,4BN/L6 Manual
RD: JUNE 2008
IM080630
RL: 1A
BA
Advertisement
Table of Contents
