Step 4: Connecting The Ac Power Cord (Mains Lead) - Sony RDR-HX750 Operating Instructions Manual

B Audio L/R (left/right) input jacks
This connection will use your TV's or audio
component's two speakers for sound.
z Hint
For correct speaker location, see the operating
instructions supplied with the connected
components.
b
Notes
• Do not connect your TV's audio output jacks to
the LINE IN (R-AUDIO-L) jacks at the same
time. This will cause unwanted noise to come
from your TV's speakers.
• With connection B, do not connect the LINE IN
(R-AUDIO-L) and LINE 2 OUT (R-AUDIO-L)
jacks to your TV's audio output jacks at the same
time. This will cause unwanted noise to come
from your TV's speakers.
• With connection A, after you have completed the
connection, make the appropriate settings in the
"Audio Out" setup (page 104). Otherwise, no
sound or a loud noise will come from your
speakers.
• When you connect the recorder to an audio
component using an HDMI cord, you will need to
do one of the following:
– Connect the audio component to the TV with
the HDMI cord, or
– Connect the recorder to the TV with a video
cord other than HDMI cord (component video
cord, S-video cord, or audio/video cord).
*1
Manufactured under license from Dolby
Laboratories.
"Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.
*2
"DTS" and "DTS Digital Out" are registered
trademarks of DTS, Inc.
Step 4: Connecting the
AC Power Cord (Mains
Lead)
Connect the supplied AC power cord (mains
lead) to the AC IN terminal of the recorder.
Then plug the recorder and TV mains leads
(AC power cords) into the mains. After you
connect the AC power cord (mains lead),
you must wait for a short while before
operating the recorder. You can operate
the recorder once the front panel display
lights up and the recorder enters standby
mode.
If you connect additional equipment to this
recorder (page 24), be sure to connect the AC
power cord (mains lead) after all connections
are complete.
1
to AC IN
2
to mains
19